Step 1:    Unclip the horizontal veneer/plastic panel beneath the heater control unit.

Step 2:    Unclip the heater control panel (3 clips in the top edge and 2 in the lower edge) with a flat bladed tool and cloth.

Step 3:    Remove the two left hand screws and loosen the two right hand screws.

Step 4:    Tilt out the matrix and locate the bracket with the two left hand screws.

Step 5:    Tighten the left hand screws and refit the panel and lower fascia.

Dashmount will not be liable for any damage caused to a vehicle in executing the fitting of the bracket