PHASE 1

Step 1:     Unclip the framework around the radio aperture.

Step 2:    Remove the upper right and left hand screws enabling the left upper corner of the fascia to be levered forwards.

Step 3:    Insert the bracket arm behind this panel and locate it with the lefthand screw.

Step 4:    Refit the fascia and other screw and refit the radio framework.

Step 5:    Refit the console and right hand screw and replace the radio.

 

PHASE 2

1. Unclip the radio housing.
 
2. Remove the four screws on the left hand side of the console.
 
3. Remove the trim around the gear shift, pulling up to unclip.
 
4. Remove the two bolts at the base of the centre console.
 
5. Unclip the storage tray beneath the heater/radio depending on configuration.
 
6. Lever the fascia out some 20mm and locate the bracket behind the panel with the lower of the four screws.
 
7. Refit all parts in reverse.