Step 1:     Begin by removing the air vents. To do this, put pressure on the outside edge and pull. The air vent will pull out. Do this for both sides. Remove the two phillips screws on the inside of the air vent cavity.

Step 2:    Remove the climate control knobs by pulling out.

Step 3:     Next, unclip the dash trim bezel by pulling out.

Step 4:    Locate and remove the factory phillips screw to the leftt of the radio. Locate the Dash Mount under the leftt side behind radio.

Step 5:     Replace factory screw and tighten. Reassemble Dash Trim in reverse order