Step 1: Remove the climate control switches.

Step 2: Unclip the small panel between the air vents. and remove the screw in the upper edge.

Step 3: Then with a flat bladed tool pry the trim away from console. This is clipped on.

Step 4: Locate and remove the 9/32 screw to the left of the H.R.W / Power Outlet switches. Position the Dash Mount over this hole and replace the factory screw. Tighten well.

Step 5 : Refit the trim bezel in reverse order.

 

Dashmount will not be liable for any damage caused to a vehicle in executing the fitting of the bracket