Step 1. Remove the screw located under the Auxiliary power outlet.

Step 2. Put on the parking brake and shift the the gear into drive and tilt the steering wheel all the way down.

Step 3. Remove the dashboard trim panel by starting at the top right and pressing down and pulling towards you. (Panel is held by clips).

Step 4. Disconnect the wiring harness for the auxiliary power outlet and lay the dashboard trim panel on top of the dashboard.

Step 5. To the right of the radio there will be a 7mm bolt. Remove this bolt and pull the radio housing out far enough so that you can insert the Dash Mount behind the radio housing. The Dash Mount should be angled toward the driver. Replace the bolt and tighten well.

Step 6. Reinstall the trim panel making sure that the dashmount comes out between the radio and the trim panel.

Dashmount will not be liable for any damage caused to a vehicle in executing the fitting of the bracket