Step 1: Remove the radio unit and the storage tray below. This one is clipped on.

Step 2: Pull out the complete panel assembly. Grab in the radio opening lower edge and

pull straight out.

Step 3: On the right side of the heather control unit you will find 2 screws. Install your Dash Mount on these 2 screws. (The Dash Mount will also fit on the 2 screws to the left side of heater control unit, but then you have to twist the mounting plate to a correct angle after it is fully installed)

Step 4: Install the panel. When positioning the panel, make sure that the Dash Mount comes out in the radio opening. Install your radio and push the tray into position.

Dashmount will not be liable for any damage caused to a vehicle in executing the fitting of the bracket