70499 - Nissan Altima 98 - 01

Step 1: Begin by removing the trim bezel that surrounds the shifter knob. To do this, pull up on the trim bezel at the rear until clips are released. A flat bending tool or hook tool is recommended. Continue around bezel until all 4 clips are released. Lift trim over shifter knob and set aside.

Step 2: Next, remove the two Phillips screws that are located in front of the shifter knob. Set aside. Remove the two Phillips screws below the climate control and set aside. With the flat bending tool, carefully remove trim bezel that surrounds the radio and climate control. Set aside.

Step 3: Remove the screw to the right of the climate control. Position the Dash Mount over this hole and replace factory screw. Reassemble the dash in reverse order.

Dashmount will not be liable for any damage caused to a vehicle in executing the fitting of the bracket