Step 1:     Begin by removing the trim bezel surrounding the radio and climate control. To do this remove two 9/32 screws. One is located behind the power accessory switch and the other is to the left of the ashtray.The bezel is clipped at the top. Pull on the lower section of the bezel and set aside. There is no need to disconnect the wires.

Step 2:     Next, remove the 9/32 screw to the left of the heater controls. Position the Safety Mount over this hole and replace factory screw.

Step 3:    Locate the bracket with this screw 

Step 4:     Reassemble dash trim bezel in reverse order.

Dashmount will not be liable for any damage caused to a vehicle in executing the fitting of the bracket