Step 1:     Remove the two screws underneath the heater controls.

Step 2:    Pull out the console, insert the brackets 'flat arm' in between the controls and the centre console to the left of the rear demister switch.

Step 3:    When you can push this arm no further, adjust the arm towards the rear demister switch and push the arm all the way in.

Step 4:    The hooked arm clips behind the console trim.

Step 5:    Locate the arm with a hole to the left hand screw, replace trim and fasten screw.

Dashmount will not be liable for any damage caused to a vehicle in executing the fitting of the bracket