71220 MAZDA 6 - (not applicable with dealer fitted CD upgrade)

NB Automatic cars have a electronic sense wire running through the gear shifter, exercise EXTREME caution when removing the gear shift panel. Excessive force will result in this wire becoming disconnected and will require soldering to effect reconnection

1. Unclip the rear gear shift panel by pulling straight up at the same time releasing the two clips at the join with the forward section.

2. Pull the second section out.

3. Remove the two Philips screws at the base of the centre console.

4. Cars with manual heater controls require the switches to be removed and the screws beneath removed also.

5. Open the glove box and press the sides of the tray inwards to release the lid.

6. Remove the 10mm in the upper inner left corner of the radio assembly.

7. Locate the bracket with the two screws on the side of the radio assembly. 8mm socket required.

8. Refit the unit and all fixings and trim

Dashmount will not be liable for any damage caused to a vehicle in executing the fitting of the bracket