Step 1:     Begin by opening the glove compartment and locating the phillips screw under the plastic cover. Remove the cover and then remove the screw. Next, at the top of the airvents are two plastic covers. One on the left and one on the right. Remove these two covers. they pull out. Remove the two screws located underneath. Just above the radio is a flat panel. This panel unclips. Remove the two screws underneath.

( Note: Use extreme caution with plastic panels and covers.)

Step 2:     Pull the complete trim bezel out. Do not disconnect wiring. Let bezel hang to the right. Remove the screw to the left of the radio and position the Dash Mount over this hole. Reinstall the factory screw. Reinstall the factory screw that was removed from the glove compartment.

Step 3: Reassemble the dash trim bezel in reverse order.

Dashmount will not be liable for any damage caused to a vehicle in executing the fitting of the bracket