CARS WITH RADIO AND INTEGRAL HAZARD WARNING SWITCH

1. Remove the radio utilising the single DIN radio tools. CARE: the tools unlock by pressing THROUGH the normal release tabs and connecting with the release mechanism behind. This process is extremely precise.

To remove the unit use the cassette recess but take care not to corrupt. The radio is seated on a rubber mount that fits tightly against the plastic surrounds. The radio can be accessed, with difficulty, from behind via the glove box.

CARS WITH SINGLE DIN UNIT.

1. Unclip the radio panel and remove radio with the tools, simultaneously.

ALL MODELS:

Step 2:     In the opening behind the panel you must remove the 2 upper screws. Pull out the air vent. assembly’s lower edge.

Step 3:     Locate the Dash Mount arm behind the locating tab on the left hand side and push the air vent. assembly back into position. Insert the screws and tighten

Step 4:     Refit the front radio panel by clipping on.

Dashmount will not be liable for any damage caused to a vehicle in executing the fitting of the bracket