Step 1:     Remove the switch assembly panel in front of the gear shift starting at the base first.

Step 2:    Remove the two Phillips screws beneath and pull the lower panel up and out.

Step 3:    Disconnect the wires and twist gear selecter to enable easier removal of the trim.

Step 4:    Remove the two Phillips screws inside the main recess and lever out the inner trim using a flat bladed tool starting in the lower right hand corner via the retaining clips.

Step 5:    Locate the bracket with the two bolts to the left of the radio.

Step 6:    Reassemble all parts in the reverse procedure.

Dashmount will not be liable for any damage caused to a vehicle in executing the fitting of the bracket